Ewheel ADC adapter V3 for diy ebike escooter with vesc
The Aadapter is compatible with normal ESC and all other VESC.
All in one function adapter for diy Electric skateboar Escooter with VESC :
- Horn, Head light, Turn Signal light, Brake and rear light, and reverse light support.
- High, middle, low, 3 level throttle support.
- Motor reverse and cruise support.
- Buzzer to remind turn and settings.
- Support both hall brake and mechanical brake input.
- Support bidirectional throttle(two-way throttle)
- Two / one motor drive support.
- Each output port (for horn/front lights/turn signal lights/brak lights) max current is 3A,12V
- Size: 63 x 53 x 12.5 mm (same size with V2 adapter)
What 's upgraded from Adapter V2?
Function Port :
Notes:
① Only connect one this UART cable in Ubox, it means two motors run in same step.
② Connect both two UART cables in Ubox, if you want to run two motors independently, then need to turn off Ubox internal can bus
③ Cruise function works by a swtich
④ Reverse funftion works by a switch
⑤ This kind of brake lever has internal swtich, it can trigger on the brake light
How to program it in VESC TOOL?
Please refer to this user manual
FAQ:
Will other VESC be compatible with Ewheel ADC adapter V3?
Yes, it works with other VESC and normal ESC(Non-VESC), but still have some difference on the power supply for the lights/horn function.
Ubox(single /dual) : there is 12v power supply port(fan port), which can supply power to the ewheel ADC adapter's output parts(horn and lights etc.)
Other VESC: mostly only have 5v output, you need to source 5v horn/lights to work with ewheel adc adapter v3
Can I use it for normal ESC, NOT VESC ?
YES, it works with normal ESC.
Shipping comes:
- Ewheel ADC adapter V3 (recommend to work with ubox V2)
- Cables (2pc* 8pin UART cable, 1pc* 12v 3pin cable, 5pcs*3pin cables,12pcs *2pin cables )
- Options for single /dual mode switch button :
- spec 12mm latching button
- cable length: 80cm