Electircal Spec:
-
Firmware : shipped with custom firmware, compatible with VESC official 100V/250A firmware
- 2 groups of 12v power port:
- 12v fan port: 3pin connector
- 12 power port : 4pin connector
- 12V port total current < 4A
- Voltage: 22S hardware design, 85V is in warranty
-
Current: 200A max (The duration depends on the temperature around the product, heat dissipation and air circulation)
-
Ports available: PPM,UART(adc1/adc2),Canbus,Hall sensor,TypeC USB, SWD port, NRF port, Ignite Key port, Power button port/12V power port *2
-
Cables and connectors: 12cm 12AWG phase wires with 4.0mm female bullet connector *6, 12cm 12AWG battery cable with XT90 male connector*4
-
Size: 140mm*91mm(Including bottom ears)*24mm / 140mm*76mm(Excluding bottom ears)*24mm
- Power button LED lights functional indication:
- Running--Green light
- Stop/begin throttling--Dim green
- Abnormal--Blinking Red
- Key Parts Spec:
- Mofet Part No: JMSH1001ATL-13
- Current amplifier PN: INA240A1
- Off state current less than 200uA
Design Feature
Aluminum Power board will transfer heat much quicker. Attention: It doesn't reduce heat source, still need cooling solution (eg. add heatsink)

It supports can bus to turn on off , much convinient to do 2WD or 4WD setup

All power circuit(12v/3.3v/5v) is protected by recovery fuse,so does to ignite key port.

More convinient power on port and extra 12v power port, and NRF port for Bluetooth module.

Build inside BMI160 module,it's convinient for diy balanced board

Shipping comes:
Firmware:
- The product is shipped with latest firmware 6.2
- Warning: Open source firmware has risky feature, Only hardware is in warranty protection.
User manual
Attention: Spintend reserve rights to do any change on the product without inform to those purchased before change, including but not limited to parts replacement and design for optimization.