Single Ubox Aluminum controller 126V 160A controller based on VESC

Electircal Spec:

• Voltage: Max voltage 126V
• Current: 160A max (The duration depends on the temperature around the product, heat dissipation and air circulation）
• Ports available: PPM,UART(adc1/adc2),Canbus,Hall sensor,TypeC USB, SWD, NRF port, Ignite Key port, Power button port/ fan power port 
• Cables : 16cm 8AWG phase wires , 16cm 8AWG battery cables 
• Size: 122mm*70mm*41mm
• Power button LED lights functional indication:
  • Running--Green light
  • Abnormal--Blinking Red
• Key Parts Spec:
  • Mosfet Part No: JMSH1504NTL
  • Current amplifier PN: INA240A1
• Off state current less than 200uA
• Fan port : 12V, 0.2A

Design Features

Full Alum PCB design to get better heat dissipation .(Attention：It doesn't reduce heat source, still need cooling solution. eg, add heatisnk and fan)

All Power circuit(3.3v/5v/12v) is protected by recovery fuse. 

It supports can bus to turn on /off, much convinient to do dual or 4WD setup by one power button

Reserved top cover hole trace inside, support cable vertical out for DIY convinience

Shipping comes:

• Shipping will come with Aluminum case and latest firmware

• Accessory pack includes:
• power button*1
• ppm cable*1
• can bus cable*1
• hall sensor cable*1
  
• fan port transfer cable*1
• 7pin ignite port cable*1
• Multifunction cable(UART&ADC) *1
• NRF port cable*1
• SWD port cable*1

Firmware:

1. The product is shipped with latest firmware 6.5, using unlimited firmware will void warranty protection.
2. Warning: Open source firmware has risky feature, Only hardware is in warranty protection.

Attention: Spintend reserve rights to do any change on the product without inform to those purchased before change, including but not limited to parts replacement and design for optimization.