Electircal Spec:
-
Firmware : shipped with custom firmware, compatible with VESC official 100V/250A firmware (Firmware Name: VESC_UBOX_SINGLE_80_FW)
- 2 groups of 12v power port:
- 12V fan port: 3pin connector
- 12V power port : 4pin connector
- 12V port total current <3A
- Voltage: max 85v
-
Current: 150A max (The duration depends on the temperature around the product, heat dissipation and air circulation)
-
Ports available: PPM,UART(adc1/adc2),Canbus,Hall sensor,TypeC USB, SWD port, NRF port, Ignite Key port, Power button port/12V power port *2
-
Cables and connectors: 12cm 10AWG phase wires with 4.0mm female bullet connector, 12cm 10AWG battery cable with XT90 male connector
- Size: 102*57*21mm
- Power button LED lights functional indication:
- Running--Green light
- Stop/begin throttling--Dim green
- Abnormal--Blinking Red
Design Feature
Aluminum Power board will transfer heat much quicker.
Three ways to turn on off controller, choose either one by your convinience
Can power on : use one power button , it can turn on/off two single ESC via can bus cable.
All power circuit(12v/3.3v/5v) is protected by recovery fuse,so does to ignite port
2pcs 12v power supply port, for lights and fan or other. Extra one NRF port for bluetooth or 2.4Ghz receiver, will make COM port spare for other application.
Build inside BMI160 module,it's convinient for diy balanced board
Stack two PCBAs design for better cooling solution and reliable structure
Shipping comes:
Firmware:
- The product is shipped with latest firmware(6.2), using unlimited firmware will void warranty protection
- Warning: Open source firmware has risky feature, Only hardware is in warranty protection.
User Manual
Wiring diagram for diy two motor scooter